At least one is required for a functional Push-Thru Lubrisizer setup.

   An exrta allows you to quickly change lubes or to finish a batch of

   bullets without stopping.  Click on the Reloading Tools tab to see setup

   and operating instructions.

   At least one is required for a functional Push-Thru Lubrisizer setup.

   Click on the Reloading Tools tab to see setup and operating instructions.

   At least one is required for a functional Push-Thru Lubrisizer setup.

   Choose a die with a diameter equal to or 0.001 inch greater than the

   groove diameter of barrel you intend to use the bullets in.  An extra

   die allows allows you to experiment with bullet diameter to find the

   best accuracy. Click on the Reloading Tools tab to see setup and

   operating instructions.

You will need a wrench to operate the lube pump. If you don't already have one this is a good quality  and you will likely find other uses for it on your reloading bench.  Click on the Reloading Tools tab to see setup and operating instructions.

You will need a 7/32 hex wrench to attach the lube pump to the side of the Lubrisizer Die Body. If you don't already have one this is a good quality and you will likely find other uses for it on your reloading bench. Be gentle. Just tighten the set screw enough to take the wiggle out. Overtightening can damage the parts and distort the die.  Click on the Reloading Tools tab to see setup and operating instructions.